Description

Product	What it does
Digital Micrometer Head — 50 mm Standard	Metric Digimatic head for the TM XY stage. Gives fast, legible digital readings in millimeters with data output for logging. Ideal when you measure in metric drawings and want fewer transcription errors. Range: 50 mm Resolution: 0.001 mm Readout: metric (mm); Digimatic data output Use on X or Y; retrofit for TM, or standard on TM-A models
Digital Micrometer Head — 50 mm Fine	Inch/metric Digimatic head with finer inch resolution. Best when you switch units or must report in inches while keeping metric capability. Range: 2 in / 50 mm Resolution: 0.00005 in / 0.001 mm Readout: inch / metric; Digimatic data output Use on X or Y; retrofit for TM, or standard on TM-A models
Manual Micrometer Head — X-axis, Metric	Traditional analog head for the X-axis in millimeters. No batteries, tactile feel, and quick reading for occasional checks. Range: 25 mm Graduation: 0.005 mm Use on TM-505B / TM-1005B stages; pairs with a metric Y head
Manual Micrometer Head — Y-axis, Metric	Matching analog head for the Y-axis in millimeters. Range: 25 mm Graduation: 0.005 mm Complement to 152-390 for full metric setups
Manual Micrometer Head — X-axis, Inch	Analog inch head for the X-axis. Good for legacy drawings and shop practices that specify inch values. Range: 1 in Graduation: 0.0001 in Use with the matching Y-axis inch head for consistent reporting
Manual Micrometer Head — Y-axis, Inch	Companion inch head for the Y-axis. Range: 1 in Graduation: 0.0001 in Completes an all-inch analog stage configuration

Notes: Digital heads support SPC/Digimatic data capture (use cable 959149, 2 m) for sending readings to a PC or printer. Manual heads are
a cost-effective choice for low-volume checks or when power/data aren’t needed. Verify mounting side and spindle orientation for your stage.